Completing The New Extender Setup

Whenever you buy a new device, either extender or router, one may think, it is difficult to complete the setup. But, in actuality, it is a very easy process. Moreover, it used to take only a few minutes, if all the steps for completing the new extender setup are taken properly. So, you should try the setup process by yourself. As most people own the Netgear router, then we are discussing the steps for completing the New Extender Setup for the Netgear Extender. If you own some other router, then also, you can follow these steps with a minor change, as steps are similar for every router. So, let’s start with them.

New Extender Setup for Netgear !

In this section, the steps for the new extender setup are being discussed. The below-mentioned steps are for the Netgear Extender, but where the change needs to be made that will be mentioned side by side.

Step 1: Keep your extender at a place that is neat and clean, and power doesn’t fluctuate.

Step 2: The existing WiFi network should be working.

Step 3: Now, connect your extender to the electrical power supply.

Step 4: After that, connect the Extender with the system using a WiFi network.

Step 5: To establish the connection, check the name of your extender in the list of available networking devices.

Step 6: Now, launch the web browser of your choice.

Step 7: Enter the default login link or IP address for your router or extender given in the manual.

Step 8: For the Netgear extender, enter the address as mywifiext.net in the URL field.

Step 9: With this, the window will open to create the account.

Step 10: After creating the account, choose the existing router’s network from the list to extend.

Step 11: Now, click on the Next button to connect.

Step 12: After that, click on the Finish button to complete the process of the New Extender Setup. 

Therefore, these are the steps for completing the New Extender Setup. Only the login link and the default credentials would be different for other manufacturer’s routers or extenders. All the other steps would remain the same.

Complete the Setup!

Once, you have completed the above-mentioned steps and test your extender’s network by connecting the device. Then, to complete the New Extender Setup, you need to disconnect the extender first. Now, connect it at the place where the signal is getting weaker for the existing network. Now, try to connect the device here. If it got connected successfully, then your setup is complete for the new extender, and you can enjoy the speed for your network.